Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing Amplitude Curve
#1
When printing amplitude curves if the value takes to long to reach 100% the table is cut off in the print out. While it may only be for appearance when including it in a final report it would be nice to be able to adjust the values shown to maybe by a 0.5 volt than by 0.1 volt so the full 0% to 100% would be shown.
Reply
#2
I should be able to automatically adjust the table increment to handle the issue. Another possibility is to put the table on multiple pages, but that is probably overkill.
Reply
#3
Agreed with the overkill. Usually just to document the curve and set points. I highly doubt any values are taken off the paper version, just window dressing in the report which satisfies some reporting requirements.
Reply
#4
It's done and will be in next release. It picks a reasonable increment (ie 0.1, 0.2, 0.5, 1.0, ...) until it fits.
Reply
#5
Awesome, thanks.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)