Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Probe Def
Is there a way to tell what probe def was used for a cal group / configuration? Is it actually identified somewhere? Each location I look in, like the summary or config only has the option to select the probe def but does not actually document which one was used. Luckily we added the 2x14 to the probe ID in the eddy admin table so it shows up as what should have been used but it would be nice to have exactly what was selected show up in the summary or config screen.


Forum Jump:

Users browsing this thread: 1 Guest(s)